MATERIALS FOR HYDROAVIATION
On September 6, 2014 at the branch of All-Russian scientific-research institute of aviation materials - G.V. Akimov Gelendjik Climatic Testing Center (GCTC VIAM) a subsection «Materials and technologies in water- and-ship-based and off-airfield aviation» of the 10-th International scientific conference on hydroaviation, which was held in the frames of «Hydroaviasalon-2014», completed its work.
A representative of VIAM Roman O. Vakhromov held the subsection. Opening the event, he wished the participants a successful and fruitful work.
A specialist of JSC«ОSPE «Technologiya»» Aleksey N. Korneychuk prepared a report «Development of thermal resistant fiberglass-reinforced plastic honeycomb fillers on a base of polyimide binder».
Vadim B. Dyunin from JSC «ТАSТС after G.М. Beriev» (Taganrog aviation scientific technical complex) told about an application of Al-Li-alloys in structures of amphibian aircrafts of ТАSТC after G.М. Beriev.
A representative of «КNRTU after A.N.Tupolev»(Kazan’ national research technical university) Ramil N. Sungatulin prepared a report «High-production technology of manufacture of small unmanned aircraft airframe from polymer composites».
A representative of VIAM Dmitriy V. Chesnokov considered the item of advanced technologies for corrosion protection and repair of aviation systems.
Candidate of Engineering Science Dmitriy V. Mashtalyar of RAS FED (Far-east department) of Chemistry institute, informed the participants about protective composite fluoropolymer coatings on magnesium alloys.
Another representative of FGBES of RAS FED (Far-east department) of Chemistry institute, Candidate of Engineering Sciences Vladimir S. Egorkin told about corrosion-resistant properties of protective superhydrophobic coatings on metals and alloys.
Roman O. Vakhromov, a representative of VIAM made a report «Corrosion-resistant aluminum alloys for amphibious aviation engineering».
Doctor of Technical Science Anatoliy V. Lyushinskiy from JSC «RIDB» (Ramensk instrument making design bureau) told about diffusion welding technology in aeronautical industry.
A representative of FSBE «ААSRI» (Arctic and Antarctic scientific-research institute) Vladimir T. Sokolov informed about experience on application of drone aircraft in the Arctic.
Sergey A. Potanin (JSC «ТАSTC after G.M.Beriev») made a report «Methods of increasing of metals machining efficiency with application of HRT (high-rate treatment)».
It should be mentioned, that after finishing of subsection work a review excursion through GCTC of VIAM was held for its participants. In particular, the guests were acquainted with specimens of materials and structural components exposed under conditions of air atmospheric ground, informed about potentialities of the Center and the tests carried out here.